收藏本站
Micrel
MICRF505BML/YML
The lengths of the N, M, and A registers are 12, 12
and 6 respectively The values can be calculated
from the following formula:
C L =
1
C 10
1
+
1
C 11
+ C parasitic
The parasitic capacitance is the pin input
( 16 × N + A ) ( 16 × N + A )
f PhD =
f XCO
M
=
f VCO 2 f RF
=
capacitance and PCB stray capacitance. Typically,
the total parasitic capacitance is around 6pF. For
instance, for a 9pF load crystal the recommended
M ≠ 0
values of the external load capacitors are 5.6pF.
where
1 ≤ A<N
It is also possible to tune the crystal oscillator
internally by switching in internal capacitance using
5 tune bits XCOtune4 – XCOtun0. When XCOtune4
f PhD : Phase detector comparison frequency
f XCO : Crystal oscillator frequency
f VCO : Voltage controlled oscillator frequency
f RF : RF carrier frequency
There are two sets of each of the divide factors (i.e.
A0 and A1). If modulation by using the dividers is
selected (that is Modulation1=1, Modulation0=0), the
two sets should be programmed to give two RF
frequencies, separated by two times the specified
frequency deviation. For all other modulation
methods, and also in receive mode, the 0-set will be
used.
Crystal Oscillator (XCO)
– XCOtune0 = 0 no internal capacitors are
connected to the crystal pins. When XCOtune4 –
XCOtune0 = 1 all of the internal capacitors are
connected to the crystal pins. Figure 6 shows the
tuning range for two different capacitor values, 1.5pF
and no capacitors.
The crystal used is a TN4-26011 from Toyocom.
Specification: Package TSX-10A, Nominal frequency
16.000000 MHz, frequency tolerance ±10ppm,
frequency stability ±9ppm, load capacitance 9pF,
pulling sensitivity 15ppm/pF. When the external
capacitors are set to 1.5pF and the XCOtune=16,
the total capacitance will normally be ~9pF.
100,0
Adr
D7
D6
D5
D4
D3
D2
D1
D0
0001001
‘0’
‘0’
‘1’
XCOtune4 XCOtune3 XCOtune2
XCOtune1
XCOtune0
80,0
60,0
The crystal oscillator is a very critical block. As the
crystal oscillator is a reference for the RF output
frequency and also for the LO frequency in the
receiver, very good phase and frequency stability is
required. The schematic of the crystal oscillator’s
40,0
20,0
0,0
-20,0
-40,0
2x1.5pF
2x0pF
external components for 16MHz are shown in Figure
5.
-60,0
0
8
16
24
32
XCO bitvalue
Pin 24
Y1
Pin 23
XTALOUT
C10
5.6pF
TSX-10A
C11
5.6pF
XTALIN
Figure 6. XCO Tuning
The start up time is given in Table 7. As can be
seen, more capacitance will slow down the start up
time.
Figure 5. Crystal Oscillator Circuit
The crystal should be connected between pins
XTALIN and XTALOUT (pin 23 and 24). In addition,
loading capacitors for the crystal are required. The
loading capacitor values depend on the total load
capacitance, C L , specified for the crystal. The load
capacitance seen between the crystal terminals
should be equal to C L for the crystal to oscillate at
the specified frequency.
The start-up time of a crystal oscillator is typically
around a millisecond. Therefore, to save current
consumption, the XCO is turned on before any other
circuit block. During start-up the XCO amplitude will
eventually reach a sufficient level to trigger the M-
counter. After counting 2 M-counter output pulses
the rest of the circuit will be turned on. The current
consumption during the prestart period is
approximately 280μA.
October 2006
16
M9999-103106
+1 408-944-0800
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
MICRF506DEV1 EVAL BOARD EXPERIMENTAL MICRF506
MICRF507YML TR TXRX FSK LOW PWR W/AMP 32MLF
MICRF600DEV1 KIT DEV RADIOWIRE 902-928MHZ
MK01-C SENSOR REED SPST-NO SMD
MK01-H SENSOR REED SPDT-CHANGE SMD
MK02/0-1A66-500W SENSOR REED SPST-NO
MK02/6-0 SENSOR REED PCB 24MM T/H
MK03-1C90C-500W SENSOR REED SPDT CYLINDER
相关代理商/技术参数
MICRF505DEV1 制造商:Micrel Inc 功能描述:KIT MICRF505 EVALUATION
MICRF505L 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:850MHz and 950MHz ISM Band Transceiver
MICRF505LYML 制造商:Rochester Electronics LLC 功能描述: 制造商:RF Micro Devices Inc 功能描述:
MICRF505LYML TR 功能描述:射频收发器 850MHz to 950MHz, 2.25V to 5.5V FSK Transceiver with +10dBm Power Amplifier RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray
MICRF505YML 制造商:Micrel Inc 功能描述:433/915MHZ ITRANSCEIVER SMD MLF32 制造商:Micrel Inc 功能描述:433/915MHZ ITRANSCEIVER, SMD, MLF32 制造商:Micrel Inc 功能描述:433/915MHZ ITRANSCEIVER, SMD, MLF32; Frequency Min:850MHz; Frequency Max:950MHz; Modulation Type:FSK; Sensitivity dBm:-111dBm; Data Rate:200Kbps; Supply Voltage Min:2V; Supply Voltage Max:2.5V; RF IC Case Style:MLF; No. of Pins:32; ;RoHS Compliant: Yes
MICRF505YML TR 功能描述:射频收发器 850MHz to 950MHz, 2.0V to 2.5V FSK Transceiver with +10dBm Power Amplifier RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray
MICRF505YML-TR 功能描述:IC RF TxRx Only General ISM < 1GHz 850MHz ~ 950MHz 32-VFQFN Exposed Pad, 32-MLF? 制造商:microchip technology 系列:- 包装:剪切带（CT） 零件状态:有效 类型:仅限 TxRx 射频系列/标准:通用 ISM < 1GHz 协议:- 调制:FSK 频率:850MHz ~ 950MHz 数据速率（最大值）:200kbps 功率 - 输出:10dBm 灵敏度:-111dBm 存储容量:- 串行接口:SPI GPIO:- 电压 - 电源:2 V ~ 2.5 V 电流 - 接收:8.6mA ~ 13.5mA 电流 - 传输:14mA ~ 28mA 工作温度:-40°C ~ 85°C 封装/外壳:32-VFQFN 裸露焊盘，32-MLF? 标准包装:1
MICRF506 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:410MHz and 450MHz ISM Band Transceiver